Madeleine Skirt #1

This is my first version of the Madeleine Skirt by Victory Patterns. I made it already in February 2018 from a remnant wool fabric with some polyester content. I like the fine herringbone weave and how the fabric feels. It's quite smooth and does not cling to tights or leggings, so no lining was necessarily needed, especially because of the width of the skirt.

I made size 8 but it turned out too wide at the waist. I tried to get away with belt loops and wearing a belt - but it puckered and with the rather heavy fabric didn't look good.

Last November I came back to it again with fresh ideas: I unpicked the waistband, belt loops, zipper and back seam. I did cut away about 2 cm at each back seam line, then inserted an invisible zipper - the look of it I like much better than the original lapped zipper. I did cut out a new waistband length according to size 6 and attached it. I didn't make a folded waistband but used the same cotton lining fabric on the inside of the waistband as I used for the pockets.

Now it fits perfect! Since it's finished I did wear it quite often this winter with leggings, at the weekends when we go for walks. The big pockets are useful at this occasions - although I might would make them smaller for "office outfits". I'm of a small body size and I have to dig quite deep into the pockets when "fishing" for small stuff... :-)

Madeleine Skirt

Victory Patterns

Fabric: 80% wool 20% polyester

Used: ca. 200cm length x 140cm width

 Size 6